Go-power GP-PWM-25 Manuel d'utilisateur télécharger pdf (Page 11)

Owner’s Manual | GP-PWM-25 Regulator

Last revised: March 2010

6.0 Operating Instructions

Power Up

When the GP-PWM-25 is connected to the battery,

the GP-PWM-25 will go into Power Up mode. The

controller will select the battery voltage automatically.

If the battery voltage is above 20 Volts the controller

assumes a 24 Volt battery system.

Icons Displayed: Three horizontal dashes

Setting the Battery Type / Charging Profile

Set the Battery Type / Charging Profile by holding

down the B Button for 10 seconds. When the display

begins blinking you may set the Battery Type by

toggling through the Charging Profile numbers 1, 2 or

3 by pressing the B Button.

Refer to the Battery Charge Profile Chart on the

following page for details on each profile.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Pas de commentaire

Go-power GP-PWM-25 Manuel d'utilisateur Page 11